UEE Series
Isolated, High-Density, Eighth-Brick
DOSA Low Pro?le DC-DC Converters
Please observe Sense inputs tolerance to avoid improper operation:
[Vout(+) ?Vout(-)] ? [Sense(+) ?Sense(-)] ≤ 10% of Vout
Output overvoltage protection is monitored at the output voltage pin, not the
Sense pin. Therefore excessive voltage differences between Vout and Sense
together with trim adjustment of the output can cause the overvoltage protec-
tion circuit to activate and shut down the output.
Power derating of the converter is based on the combination of maximum
output current and the highest output voltage. Therefore the designer must
insure:
(Vout at pins) x (Iout) ≤ (Max. rated output power)
Trimming the Output Voltage
The Trim input to the converter allows the user to adjust the output voltage
over the rated trim range (please refer to the Speci?cations). In the trim equa-
tions and circuit diagrams that follow, trim adjustments use either a trimpot or
a single ?xed resistor connected between the Trim input and either the +Sense
Trim Equations
or –Sense terminals. Trimming resistors should have a low temperature coef-
?cient (±100 ppm/deg.C or less) and be mounted close to the converter. Keep
leads short. If the trim function is not used, leave the trim unconnected. With no
trim, the converter will exhibit its speci?ed output voltage accuracy.
There are two CAUTIONs to observe for the Trim input:
CAUTION: To avoid unplanned power down cycles, do not exceed EITHER
the maximum output voltage OR the maximum output power when setting the
trim. Be particularly careful with a trimpot. If the output voltage is excessive,
the OVP circuit may inadvertantly shut down the converter. If the maximum
power is exceeded, the converter may enter current limiting. If the power is
exceeded for an extended period, the converter may overheat and encounter
overtemperature shut down.
CAUTION: Be careful of external electrical noise. The Trim input is a senstive
input to the converter’s feedback control loop. Excessive electrical noise may
cause instability or oscillation. Keep external connections short to the Trim
input. Use shielding if needed.
R TrimDn (k Ω) = 5.11 ? 10.22
R TrimUp (k Ω) = 5.11 × V NOM × (1+ ? ? ? 5.11 ? 10.22
Trim Down
Connect trim resistor between
trim pin and ?Sense
?
Trim Up
Connect trim resistor between
trim pin and +Sense
1.225 × ? ?
Where,
??????? V NOM ? V OUT ) / V NOM ?
V NOM is the nominal, untrimmed output voltage.
V OUT is the desired new output voltage.
Do not exceed the speci?ed trim range or maximum power ratings when adjusting trim.
Use 1% precision resistors mounted close to the converter on short leads.
If sense is not installed, connect the trim resistor to the respective V OUT pin.
Trim Circuits
+VIN
+VOUT
+SENSE
+VIN
+VOUT
+SENSE
ON/OFF
CONTROL
TRIM
LOAD
ON/OFF
CONTROL
TRIM
R TRIM UP
LOAD
–SENSE
–SENSE
–VIN
–VOUT
Figure 10. Trim Connections Using A Trimpot
–VIN
–VOUT
Figure 11. Trim Connections To Increase Output Voltages
Connect sense to its respective V OUT pin if sense is not used with a remote load.
www.murata-ps.com/support
MDC_UEE_Series.C01 Page 27 of 29
相关PDF资料
UEI15-050-Q12P-C CONV DC/DC 15W 5V 3A
UEI25-120-D48PM-C 36-75VIN 12VOUT 25W POS LOG SMD
UEI30-050-Q48N-C CONVERT DC/DC 30W 5V SNGL NEG
UEP1H470MPD CAP ALUM 47UF 50V 20% RADIAL
UES1V100MEM CAP ALUM 10UF 35V 20% RADIAL
UFG1V470MEM CAP ALUM 47UF 35V 20% RADIAL
UHD1A332MHD CAP ALUM 3300UF 10V 20% RADIAL
UHM0J102MPD3 CAP ALUM 1000UF 6.3V 20% RADIAL
相关代理商/技术参数
UEE-3.3/30-D48P-C 功能描述:DC/DC转换器 99W 3.3V 30A Pos Polarity TH RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压(标称): 输出端数量:1 输出电压(通道 1):3.3 V 输出电流(通道 1):600 mA 输出电压(通道 2): 输出电流(通道 2): 安装风格:SMD/SMT 封装 / 箱体尺寸:
UEE-3.3/30-D48PM-C 功能描述:DC/DC转换器 99W 3.3V 30A Pos Polarity SMT RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压(标称): 输出端数量:1 输出电压(通道 1):3.3 V 输出电流(通道 1):600 mA 输出电压(通道 2): 输出电流(通道 2): 安装风格:SMD/SMT 封装 / 箱体尺寸:
UEE-3.3/45-D48NB-C 功能描述:DC/DC CONVERTER 3.3V 150W 制造商:murata power solutions inc. 系列:UEE 150W 包装:托盘 零件状态:有效 类型:隔离模块 输出数:1 电压 - 输入(最小值):36V 电压 - 输入(最大值):75V 电压 - 输出 1:3.3V 电压 - 输出 2:- 电压 - 输出 3:- 电流 - 输出(最大值):45.5A 功率(W) - 制造系列:150W 电压 - 隔离:2.25kV(2250V) 应用:ITE(商业) 特性:远程开/关,OCP,OTP,SCP,UVLO 安装类型:通孔 封装/外壳:8-DIP 模块,1/8 砖 大小/尺寸:2.30" 长 x 0.90" 宽 x 0.50" 高(58.4mm x 22.9mm x 12.7mm) 工作温度:-40°C ~ 85°C 效率:92% 功率(W) - 最大值:150W 标准包装:21
UEE-3.3-15-D48 制造商:MURATA 制造商全称:Murata Manufacturing Co., Ltd. 功能描述:Isolated, High-Density, Eighth-Brick DOSA Low Profi le DC/DC Converters
UEE-3.3-25-D48 制造商:MURATA 制造商全称:Murata Manufacturing Co., Ltd. 功能描述:Isolated, High-Density, Eighth-Brick DOSA Low Profi le DC/DC Converters
UEE-3.3-30-D48 制造商:MURATA 制造商全称:Murata Manufacturing Co., Ltd. 功能描述:Isolated, High-Density, Eighth-Brick DOSA Low Profi le DC/DC Converters
UEE-5/30-D48NB-C 功能描述:DC/DC CONVERTER 5V 150W 制造商:murata power solutions inc. 系列:UEE 150W 包装:托盘 零件状态:有效 类型:隔离模块 输出数:1 电压 - 输入(最小值):36V 电压 - 输入(最大值):75V 电压 - 输出 1:5V 电压 - 输出 2:- 电压 - 输出 3:- 电流 - 输出(最大值):30A 功率(W) - 制造系列:150W 电压 - 隔离:2.25kV(2250V) 应用:ITE(商业) 特性:远程开/关,OCP,OTP,SCP,UVLO 安装类型:通孔 封装/外壳:8-DIP 模块,1/8 砖 大小/尺寸:2.30" 长 x 0.90" 宽 x 0.50" 高(58.4mm x 22.9mm x 12.7mm) 工作温度:-40°C ~ 85°C 效率:92% 功率(W) - 最大值:150W 标准包装:21
UEF-AUTOESL-25 制造商:Xilinx 功能描述:UNIVERSITY AUTOESL, 25 LICENSE BUNDLE - Virtual or Non-Physical Inventory (Software & Literature) 制造商:Xilinx 功能描述:AUTOESL 25 LICENSE BUNDLE